Solar generator runtime calculator

Our top pick

Chosen from listing specs for this guide.

A full day of essentials

Jackery HomePower 2000 Plus v2

  • 2,048Wh covers a full day of fridge and essentials
  • Expands to 12kWh as your outages or needs grow
  • 2,400W output and priority routing for essential loads

Check price on Amazon

Add the appliances you want to keep running, set the size of the power station, and see how many hours or days it covers. The formula is printed under the calculator so you can check every number.

Solar generator runtime calculator

The starting list is a typical household example (average fridge, three room lights, a few kitchen appliances, phone and laptop chargers). Edit, remove or add lines: enter running watts from the label or manual and how many hours a day each one actually draws power.

Formula: daily energy (Wh) = sum of watts x hours per day. Usable energy = capacity x usable share. Runtime (days) = usable energy / daily energy. Peak load = sum of running watts of everything that can run at once; compare it with the station's continuous AC rating, and check starting watts for motors and compressors separately. The 85% default is our planning assumption, not a measured figure: real losses change with load, temperature, settings and model.

How to get good numbers

  1. Find running watts on the appliance label, the manual or the power adapter. Adapters often list output volts and amps: multiply them for watts.
  2. For a refrigerator, use the yellow EnergyGuide label. Its estimated yearly kWh divided by 365 gives daily kWh; multiply by 1,000 for daily Wh.
  3. Enter hours of real use per day, not hours plugged in. A router runs 24 hours; a microwave might run 10 minutes (0.17 hours).
  4. Leave the usable share at 85% unless your manual publishes a different usable capacity or efficiency figure.
  5. Check starting (surge) watts separately for anything with a motor or compressor. The calculator only adds running watts.

Where to go next

What if...? Real-life scenarios

Common situations for this topic, with the product we would start with and the math behind it. Appliance figures are examples: check your own labels.

What if I do not know how many hours a day an appliance runs?

Estimate actual running time, not plugged-in time. A plug-in electricity usage meter over a day gives the real figure.

What if my appliance lists amps instead of watts?

Multiply volts by amps: 120V x 2A is 240W. That is a conservative maximum; real running watts are often lower.

What if the result is less than a day?

Remove optional loads, add an expansion battery, or plan solar or another charging source. Then recalculate.

What if my fridge cycles on and off?

Use the EnergyGuide label: yearly kWh divided by 365, times 1,000, gives daily Wh. Enter it as running watts times hours that match that total.

What if the realistic peak is above my station's output?

Run big appliances one at a time, or choose a station with more continuous output. Motors also need surge headroom.

What if I mostly use USB and DC outlets?

DC loads skip the inverter, so your real usable share can be higher than 85%. Leave the default for a cautious estimate.

What if my manual lists a usable capacity?

Use it: set the usable share to the manual's usable capacity divided by the rated capacity.

What if it will be very cold?

Cold reduces usable capacity and can block charging. Lower the usable share for a more cautious estimate and keep the unit indoors.

What if I want to plan solar recharging?

Daily harvest is roughly panel watts x peak sun hours x 0.75 (our derate). Compare that with your daily energy result.

What if I am sizing for medical equipment?

Use the device maker's power figures and ask them which backup they recommend. Do not rely on an estimate alone.